Metrohm viva 1.0 (process analysis) - Manual (Page 538)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
526 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
NOTE
We recommend masking the irrelevant output lines with an asterisk *
so as not to modify these line statuses.
5.5.2.9.3 SCAN
5.5.2.9.3.1 SCAN - Overview
Dialog window: Method ▶ SCAN ▶ Properties... ▶ SCAN - 'Command name'
Command for scanning remote input lines.
Instruments
This command can be executed with the following instruments:
Voltammetry: 894
Dosing Interface: 846
Sample changer: 814, 815, 858, 919
Spectrometer: Avantes
Appearance
The command has the following appearance:
Parameters
The parameters for the SCAN command are configured in the following
dialog window:
￭ SCAN - Properties
Command variables
The following command variables are generated by the SCAN command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':
Identification Description
BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started