Metrohm viva 1.0 (process analysis) - Manual (Page 472)

5.5 Method run subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
460 ￭￭￭￭￭￭￭￭
viva 1.0 (for Process analysis)
Commands
￭ CAL Spec
Measuring command for wavelength calibration.
￭ CAL LOOP Opt
Loop command for the calibration of colorimetric sensors.
￭ CAL MEAS Opt
Command for measuring standard solutions for the calibration of col-
orimetric sensors.
5.5.2.6.2 CAL Spec
5.5.2.6.2.1 CAL Spec - Overview
Dialog window: Method ▶ CAL Spec ▶ Properties... ▶ CAL Spec - 'Command
name'
Command for wavelength calibration.
Instruments
This command can be executed with the following instruments:
Spectrometer: Avantes
Appearance
The command has the following appearance:
Parameters
The parameters for the CAL Spec command are set on the following
tabs:
￭ General/Hardware
Parameters for instrument.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Calibration wavelengths
Entry of the reference wavelengths, definition of the behavior of the
calibration.
Command variables
The following command variables are generated by the CAL Spec com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':