Banner D10 Series - Manual

Printed in USA 03/09 P/N 64154 rev. F
D10 Expert ™ – Dual Discrete Outputs
Advanced sensor for use with plastic fiber optics
Models
Features
Easy-to-set automatic • Expert-style TEACH options* including static, dynamic, and
single-point programming plus manual adjustment for fine-tuning
16-bit microcontroller and 12-bit Analog-to-Digital converter for high-performance,
•
low-contrast sensing
Easy-to-read 4-digit display for TEACH and signal strength readout, plus indicators
•
for a continuous readout of operating status (user configurable)
Two discrete outputs, PNP or NPN
•
Four-mode power and speed selection with automatic cross-talk avoidance circuitry •
Selectable OFF-delay options •
Gate input wire can be used to selectively inhibit sensor outputs from switching •
Models available with visible red (680 nm) or visible green (525 nm) sensing beam •
Models available with 2 m or 9 m (6.5' or 30') cable or integral Pico-style •
quick-disconnect
Sleek, ultra-slim 10 mm housing, mounts to a standard 35 mm DIN rail
•
* U.S. Patent #5,808,296
* 9 m (30 ' ) cables are available by adding suffix “W/30” to the model number of any cabled sensor (e.g., D10DNFP W/30).
A model with a QD connector requires a mating cable (see page 14).
WARNING . . .
Not To Be Used for Personnel Protection
Never use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.
These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications.
A sensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner Safety
Products catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.
Models
Cables* Discrete Outputs
Red Beam Green Beam
D10DNFP D10DNFPG 2 m (6.5') Cable
NPN
D10DNFPQ D10DNFPGQ 6-pin Pico-style QD
D10DPFP D10DPFPG 2 m (6.5') Cable
PNP
D10DPFPQ D10DPFPGQ 6-pin Pico-style QD