Tweco VAF4 Transmig - Manual (Page 38)

TRANSMIG VAF4
INSTALLATION, OPERATION AND SETUP 3-20 Manual 0-5231
2. Remove the front panel from the base.
a. Disconnect the Cable Assembly from the Motor Control PCB.
b. Disconnect the Earth Wire from the front panel.
c. Remove the two M6 × 16 pan-head screws to disconnect the front panel from the base assembly.
Keep the two screws for future use.
Display PCB Motor Control PCB
Cable Assembly
Earth Wire
Art # A-11521_AB
Screw
Front Panel
Figure 3-13 Removing Front Panel
3. Loosen the two M5 screws and remove the plastic flange from the front panel. Keep the two screws for
future use.
Thumb Screw
Front Panel
Plastic Flange, Euro
Screw，M5
Pan- head Screw，M6 × 16
Set Screw , M6 × 6
Art # A-11364_AB
8 Pin Control Socket
Figure 3-14 Removing Front Panel and Plastic Flange
4. Disconnect the gas hose.
a. Remove the hose clamp over the gas hose.
b. Remove the gas hose from the euro adaptor.