Tweco VAF4HD Transmig - Manual (Page 31)

TRANSMIG VAF4HD
Manual 0-5269 3-13 INSTALLATION, OPERATION AND SETUP
Advanced Feature Left Display
Feature Description
Right Display
Parameter / Selection
Restore Factory Defaults 1
This resets all the user adjustable
values in this table (except Arc
Hour Accumulated Runtime) to the
Factory Default Values.
Restore Factory
Default No / YES
caution
Schedule SCH1 & SCH2 settings will be reset to factory default
settings when YES is selected with Restore Factory Defaults.
Exit Advanced Features Mode: by pressing both the left knob and right knob at the same
time for more than 1.2 seconds to Save the Settings and exit advanced features mode.
Note if there has been no user input for 30 seconds, the VAF4HD will save settings and
automatically exit advanced programming mode.
Table 3-4 Advanced Features
Factory Default Setting
Factory Default Setting of Non-Schedule: Trigger mode: 2T; Wirefeed speed: 11.5 MPM; Voltage: 29.0V.
Suits; Autocraft LW1-6, 1.2mm Hard Wire with Shielding Gas:- 81.25% Ar, 16% CO
2
, 2.75% O
2
.
Factory Default Setting of Schedule 1: Wirefeed speed: 13.0 MPM; Voltage: 30.0 V.
Suits; Verti-Cor 3XP, 1.2mm Flux Cored with Shielding Gas:- 75 - 80% Ar, 20 - 25% CO
2
.
Factory Default Setting of Schedule 2: Wirefeed speed: 9.0 MPM; Voltage: 29.0V.
Suits; Verti-Cor 3XP, 1.6mm Flux Cored Wire with Shielding Gas:- 75 - 80% Ar, 20 - 25% CO
2
.
Advanced Feature Left Display
Feature
Description
Right Display
(Default)
Comments
MIG Control MIG/CNTR LOCL
Pre Flow PRE/FLOW 0.1
Run In RUN/IN 70
Ramp Time RAMP/TIME 0.2
Post Flow POST/FLOW 0.1
Burn Back BURN/BACK 0.15
Crater CRAT OFF Only in 4T Mode
Crater Volts CRAT/ VOLT 70
Only when in 4T Mode
and Crater is ON
Crater Wirefeed Speed CRAT/ WFS 70
Only when in 4T Mode
and Crater is ON
Spot Time SPOT/TIME 2.0 Only in Spot Mode
Stitch Mode STCH OFF Only in 2T & 4T Modes
Stitch Time STCH/TIME 2.0 Only when Stitch is ON
Dwell Time DWEL/TIME 0.5 Only when Stitch is ON
Wirefeed Speed Units WFS/UNIT MPM
Left Display Type LEFT/DISP AMPS
Right Display Type RGHT/DISP VARC
Table 3-5 Factory Default Setting