Tweco VAF4HD Transmig - Manual (Page 34)

TRANSMIG VAF4HD
INSTALLATION, OPERATION AND SETUP 3-16 Manual 0-5269
3.11 Installing Handle Assembly
!
WARNING
This handle is not designed to lift wirefeeder by mechanical means. Handle is to be used for Lifting by
Hand Only.
For Mechanical Lifting use Lifting Eye Kit W4016700.
The following components are included:
Description Quantity
Handle Assembly 1
Bolt, M10 × 50 (with torque 45~59 N.m.) 2
Flat Washer, M10 (with torque 45~59 N.m.) 4
Spring Washer, M10 (with torque 45~59 N.m.) 2
Nut, M10 (with torque 45~59 N.m.) 2
Table 3-7 Handle Assembly
Install the handle assembly as below:
Secure the handle assembly to the base assembly with M10 x 50 Bolts, M10 Flat Washers, M10 Spring Wash-
ers and M10 Nuts as shown in Figure 3-8.
Bolt, M10 × 50
Flat Washer, M10
Spring Washer, M10
Nut, M10
Handle Assembly
Art # A-11758
Figure 3-8 Installing Handle Assembly
!
WARNING
Fully tighten all the fasteners with torque 45~59 N.m.
Refer to the figure below for the assembled handle assembly:
Handle Assembly
Art # A-11759
Figure 3-9 Assembled Handle Assembly