Tweco VAF4HD Transmig - Manual (Page 37)

TRANSMIG VAF4HD
Manual 0-5269 3-19 INSTALLATION, OPERATION AND SETUP
Removing Tweco No. 4 MIG Torch Adaptor
1. Remove the top cover from the base.
a. Open side door to access door earth wire.
b. Disconnect the earth wire from the door and then close the door again.
c. Remove the six screws on the top cover and the four screws on the side of the cover, then remove the
cover. Keep the screws for future use.
Art # A-11762
Earth Wire
Figure 3-12 Removing Earth Wire
Art # A-11763
Screw Hole
Screw
Star Washer
Screw
(Note: Some screws not shown
for clarity of picture)
Figure 3-13 Removing the Cover