Tweco VAF4HD Transmig - Manual (Page 54)

TRANSMIG VAF4HD
INSTALLATION, OPERATION AND SETUP 3-36 Manual 0-5269
!
WARNING
If the Gun Trigger is used to feed wire through the gun, the electrode wire will be at welding voltage
potential whilst it is being fed through the wirefeeder system.
!
WARNING
Before connecting the work clamp to the work piece make sure the mains power supply is switched off.
NOTE
VAF4HD default setting is for Transmig 550i. Refer to Table 3-6 on Page 3-14 for settings for Transmig
350i & 450i.
Connection to Transmig 350i, 450i, 550i
Positive Welding
Terminal (+)
Work Lead
19 Pin Control Socket
Negative Welding Terminal (-)
VAF4HD Wirefeeder
Tweco No. 4 MIG Torch
Art # A-11781
Figure 3-34 Setup for Wirefeeder with MIG (GMAW) Welding with Gasless MIG Wire