SARGENT Profile Series v.G1.5 Exit Devices - Manual (Page 12)

10
800-810-WIRE (9473) • www.sargentlock.com • A7757B
Profile Series v.G1 Exit Device
Copyright © 2006, 2008, Sargent Manufacturing Company
, an A
SSA ABL
O
Y
Group company
. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
Installation Instructions for Mortise Type Exit Device 8977/8978
Inside
Outside
Left Hand
Reverse Bevel
"LHRB"
Right Hand
Reverse Bevel
"RHRB"
IMPORTANT: BEFORE STARTING
• Check hand of door - this
device is not reversible
• Door should be fitted and hung
Verify box label for size of exit
device, function and hand
Step #1 - Exit Hardware & Door Prep
Prep door according to Exit installation instructions A6705 and appropriate templates
(metal door templates 4537 and 4538; wood door templates A7460 and A7461).
Step #2 - Install Outside Trim, Exit Chassis and Cylinder
A. Outside Trim
1. Slide mortise lock into door and securely fasten with (2) flat head screws
2. For exterior applications gasket (52-0263) should be used to seal
between “ET” escutcheon and outside door surface
3. Route “ET” harness through wire cutout and out other side of door
4. Place “ET” control on door with spindle inserted through mortise lock
Outside of door
(2) Flat
head
wood
screws
ET Spindle
ET Control
Wire
harness
Mortise lock
Connector
Centerline for
(2) 1/4 - 20 x 2-3/8''
flat head
machine
screws
ET gasket
7