Great Plains NTA3007 Operator Manual - Manual (Page 50)

46 NTA907 or NTA3007 Table of Contents Index Great Plains Manufacturing, Inc.
166-371M Table of Contents Index 2012-07-02
Fold: Two Wing End Locks to ROAD
Refer to Figure 37
7.
Reverse the catching direction of the wing end locks.
Pull the handle outward. Rotate the pin 180 degrees,
placing the angled surface to the rear and the longer
side of the tip to the front.
Note: This allows the plate to push the pin aside during
tilt-up, and catches the plate to hold the wing up in
transport.
Fold: Tilt Wings Up
Drill configuration and wing lock setup must be complete
(step 1 through step 7 starting on page 45) before
performing the next steps.
Refer to Figure 38
8.
On the CFM switch, enable the Tilt solenoid valve by
setting switch Tilt on.
9. Initiate tilt-up by extending the tilt cylinders.
10. Observe the tilt-up operation.
11. When movement stops, end cylinder extension.
Figure 37
Wing End Lock: FIELD to ROAD
29385
ROAD FIELD
Figure 38
CFM Tilt-Up Enable
29380
Tilt-Up Initiate: Hydraulic Circuit Operation
Lift
Fan,
Auger
Fold, Tilt,
Marker
Transport
Hooks
Neutral Neutral Extend Neutral
Figure 39
Tilt Up Progression
32405
32406
32407
Tilt-Up Initiate: Hydraulic Circuit Operation
Lift
Fan,
Auger
Fold, Tilt,
Marker
Transport
Hooks
Neutral Neutral Neutral Neutral