Great Plains 3PYP Predelivery Manual - Manual (Page 17)

Plan The Mainframe Unload 13
07/19/2011 401-312Q
Three Lift Points
Refer to Figure 14, Figure 16 and Figure 17
Using three lifters, position one (with the highest capac-
ity) at center frame rear, and lift via center frame side
tubes, as for single-lift (ref).
FigureSpacer:
Position the other two lifters near, but not beyond, the
center-to-wing connection. Make sure both forks are
inboard, and lifting only the center section.
Unstable Load Risk:
Two observers are needed, one for front-back level, and the
other for side-to-side.
Unstable Load Risk:
The observers need to pay close attention to planter level, and
signal each lift operator how to compensate if imbalance is
detected.
FigureSpacer:
Figure 16
Three-lift points
25352
FigureSpacer:
Figure 17
Front Side Lift Point
25353