Great Plains 3PYP Predelivery Manual - Manual (Page 46)

42 3PYP
401-312Q 07/19/2011
Install Steering Console
Refer to Figure 72
1.
Install the console in the tractor cab where it is
within convenient reach, does not obstruct vision, but
can be quickly observed if a fault occurs.
2. Set STEER (master) switch OFF.
Assemble Tractor Sensor
Refer to Figure 73
If the sensor is pre-assembled, loosen collar bolt
and
skip to step 9.
3. Select one each:
411-582D YOKE
802-167C HHCS 1/4-20X1 1/2 GR5
804-007C WASHER FLAT 1/4 SAE PLT
4. Insert the shorter bolt into the flat washer , and
then into the yoke from the lug side.
5. Select one each:
411-581D COLLAR
802-097C HHCS 1/4-20X2 1/2 GR5
803-255C NUT HEX NYLOCK 1/4-20
6. Align yoke side holes with collar base holes
and insert bolt . Secure with lock nut . Tighten
to allow free pivoting of the yoke with little or no side-
to-side slack.
7. Select one each:
401-541S SENSOR LIN
Gently extend the rod to full length. Measure and
record the overall length of the sensor. Gently push
the rod fully into the cylinder sleeve. Measure and
record the overall length. Add those measurement
and divide by 2. Record this [centered] length.
8. Select one each:
802-167C HHCS 1/4-20X1 1/2 GR5
803-255C NUT HEX NYLOCK 1/4-20
9. Slide collar about 1in (2.5cm) onto base end of
sensor , with vent hole near cylinder base pointing
down, and loosely secure with bolt and lock
nut through collar clamp holes.
Install Tractor Steering Sensor
Instructions for the next step depend on the brand and model of tractor:
Case IH MX or Magnum Skip to “Case IH MX/Magnum Installation” on page 43.
John Deere 8000 Series RFS Skip to “John Deere 8000 (RFS) Installation” on page 45.
John Deere 8000 Series ILS Skip to “John Deere 8000 ILS Installation” on page 47.
FigureSpacer:
Figure 72
Steering Console
29850
65
2
65
2
61
59
61
64
FigureSpacer:
Equipment Damage Risk:
Handle linear displacement sensor
carefully.
It is a precision instrument.
Note: Final collar position is determined at installation.
Figure 73
Tractor Steering Sensor Assy.
29203
51
51
62
61
58
60
62
59
64
61
FigureSpacer:
1in (2.5cm)
61 64
59
58
60
62
59 58
60 62
51
CenteredLength
MaxLength MinLength +
2
------------------------------------------------------------ =
61
62
58
51
61
62