Great Plains 3PYP Predelivery Manual - Manual (Page 18)

14 3PYP
401-312Q 07/19/2011
Four Lift Points
Refer to Figure 14, Figure 16, Figure 17 and Figure 19
Using four lifters, position one (with the highest capacity)
at center frame rear, and lift via center frame side tubes,
as for single-lift.
FigureSpacer:
Position one lifter at the hitch, and lift via the cross-tube
of the hitch, as for 2-lift.
Position the other two lifters near, but not beyond, the
center-to-wing connection, as for 3-lift. Make sure both
forks are inboard, and lifting only the center section.
Unstable Load Risk:
Two observers are needed, one for front-back level, and the
other for side-to-side.
Unstable Load Risk:
The observers need to pay close attention to planter level, and
signal each lift operator how to compensate if imbalance is
detected.
EOD: Plan The Mainframe Unload
FigureSpacer:
Figure 18
4-Lift Regions
25348
{
{
FigureSpacer:
Figure 19
Four-lift in Progress
25354