Great Plains 3PYP Predelivery Manual - Manual (Page 31)

Planter Assembly 27
07/19/2011 401-312Q
Lower Seed Box Structure
71. Check tire pressure. See “Tire Inflation Chart” on
page 58.
72. Depending on how the structure is being supported,
use the lift-assist cylinders, hoist or lift to lower the
seed box structure onto the tires.
Remove Hopper (Option)
If no seed hopper was included, skip to step 76.
Refer to Figure 47
73. Remove the bolts holding the hopper shipping
bracket . The bracket and bolts are not reused.
FigureSpacer:
Refer to Figure 48
74. Remove the U-bolt and bar
restraining the hop-
per on the opposite side. The bar and fasteners are
not reused.
75. Use a fork lift to remove the hopper and set it out of
the way temporarily.
Note: For shipping, the hopper was installed sideways on
the seed support structure. It must be removed and
correctly remounted before use. Remount is done
at step 132.
FigureSpacer:
FigureSpacer:
Figure 47
Hopper Shipping Bracket
25369
1 1
FigureSpacer:
Figure 48
Hopper Shipping U-Bolt
25370
2
2