4 program and run the system, Chapter 4. program and run the system, Program and run the system – Bio-Rad Gene Pulser MXcell™ Electroporation System User Manual
Page 28
Gene Pulser MXcell™ System Manual
19
4
Program and Run the System
The Gene Pulser MXcell™ electroporation system runs experiments with Pre-Set protocols,
or with protocols that you create. To run an electroporation experiment, you can either
program a new protocol or select an existing protocol.
This chapter includes instructions for programming protocols, running protocols, or using
other system functions:
•
Turn on the Gene Pulser MXcell system (page 20)
•
Select the
Protocol Set-up option to program new protocols in the whole plate
or in well sets (page 20)
•
Select the
Gradient Protocol option to program a new gradient protocol in the
whole plate or in quadrants (page 22)
•
Select the
User Protocols option to open user protocols (page 24)
•
Select
Pre-Set Protocols option to open pre-set protocols (page 25)
•
Open the
Last Pulse option to view the last pulse that was delivered (page 26)
•
Open the
Data Management option to view data from delivered protocols (page 26)
•
Select the
Screen Intensity option to change the LCD brightness (page 27)
•
Select the
Measurements option to check buffer resistance and capacitance
•
Save a new protocol or an edited protocol (page 28)
•
Add a new user with the
User Protocols option (page 29)