Bio-Rad PowerPac™ HV High-Voltage Power Supply - Manual (Page 25)

Step Procedure Description
8. Select the time mode Use the soft keys to select a time mode and the
alphanumeric keypad to enter the run time.
HRS: Run time is in units of hours.
VHOURS: Run time is in units of volt-hours.
UNTIMED: Run is continuous.
Note: Steps programmed after an untimed step are
ignored.
Press EDIT to return to the Method Screen.
9. Add a new step or To program additional steps press the down arrow
save the method key to select the empty step and repeat Steps 5–8.
If the method will not be saved, go directly to Step 10.
Press SAVE and then go to Step 10.
Press DELETE to delete a selected step.
Press the METHOD soft key to return to the Method
List.
10. Start the run Press to start a run.
11. Monitor the run The RUN screen is used to monitor run parameters
or to pause a run. The current step, Volts, mA and
Watts values, elapsed time versus the programmed
time, and total elapsed time are displayed on the
RUN screen. The method step is also indicated.
This run is executing Step 1 of 2.
The run may be paused by pressing the PAUSE
soft key or the
key.
To edit the run parameters during PAUSE see
Section 4.5. Edits made during the run may be
saved, if the SAVE soft key is pressed at the end of
the run. Otherwise the method will remain as
originally created.
To terminate the run, press the key.
12. The Run Completed or Run Terminated screen is
displayed at the end of a run. Press RERUN to
repeat the run or EXIT to display the method step
list.
17
500 mA
400 W
S1/1 EDIT TIME
TIME: UNTIMED
HRS VHOURS UNTIMED
PowerPac HV – Instruction Manual