Bio-Rad PowerPac™ HV High-Voltage Power Supply - Manual (Page 32)

Step Procedure Description
7. Select the time mode Use the soft keys to select a time mode and the
alphanumeric keypad to enter the run time.
HRS: Run time is in units of hours.
VHOURS: Run time is in units of volt-hours.
UNTIMED: Run is continuous.
8. Start the run Press to start a run.
9. Monitor the run The RUN screen is used to monitor run parameters
or to pause a run. The current step, V, voltage
ramping, mA and W, elapsed time versus the
programmed time, and total elapsed time are
displayed on the run screen.
The run may be paused by pressing the PAUSE
soft key or the
key.
To edit the run parameters during PAUSE see step 6.
To Edit preference see Section 3. Edits made
during the run may be saved if SAVE soft key is
pressed at the end of the run. Otherwise the method
will remain as originally created.
To terminate the run, press the key.
Note: If the temperature reaches 5° over the set
temperature, an alarm will sound intermittently until
the situation is resolved. That is, until the power is
reduced or the temperature of the gel drops. The
alarm sounds similar to the end of run, but repeats.
10. The Run Completed or Run Terminated screen is
displayed at the end of a run. Press RERUN to
repeat the run or EXIT to display the method step
list.
24
EDIT TIME
5000
500
50¡
V
mA
C
TIME: UNTIMED
HRS
VHOURS UNTIMED
55 W
PowerPac HV – Instruction Manual