Bio-Rad ProteinChip Data Manager Software - Manual (Page 11)

Page 6
ProteinChip SELDI System: Reader Guide
glasses must have an optical density of >5 at 337 nm. Care should be taken to
avoid specular reflection of the beam. Laser energy levels up to 250 µJ at
337 nm could be accessible in the interior if the inner cover is removed.
High Voltage
Warning: The unit contains high-voltage power supplies. While the components
are fully insulated under normal conditions, electrostatic charge can accumulate
on wires and feedthroughs carrying high voltage as well as nearby components.
Contact with these components should be avoided when high voltage may be
present.
Radio Frequency Energy
Note: This equipment has been tested and found to comply with the limits for
a Class A digital device, pursuant to part 15 of the Federal Communications
Commission (FCC) rules and regulations. These limits are designed to provide
reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference, in which case the user will be required to correct
the interference at his expense.
Set Up
Requirements The ProteinChip SELDI reader (Fig. 6) is approximately 115 cm high, 59 cm
wide, and 79 cm deep. The reader will fit on a normal height laboratory
bench. The reader will be delivered in a packing case and weighs about
105 kg. The packing case must be unloaded and moved with a forklift or
pallet jack.
Packing Case
143 cm (H) x 84 cm (W) x 89 cm (D)
ProteinChip SELDI Reader
115 cm (H) x 59 cm (W) x 79 cm (D)
Weight 105 Kg
4 x 120 V in US
2 x 13 A in EU
2 m bench space