Bio-Rad ProteinChip Data Manager Software - Manual (Page 44)

Networking the ProteinChip SELDI System Using Static IP Addresses Page 39
If you need to configure a separate computer to communicate with the reader,
please see the troubleshooting section.
1. Make sure that no one is using the reader.
2. Open Internet Explorer on the client workstation.
3. Enter the following URL into the address bar:
http://192.168.1.200.
The reader web page shown in Fig. 36 will appear.
Fig. 36: The reader web page.
4. Click on the Settings link. The Network Settings page will appear
(Fig. 37).