Bio-Rad ProteinChip Data Manager Software User Manual
Page 37
Page 32
Networking the ProteinChip SELDI System
ProteinChip SELDI System: Reader Guide
Fig. 28: The Internet Protocol (TCP/IP) Properties dialog box.
2.
Click on Obtain an IP address automatically and click OK.
3.
Test the connection. Use a different computer already on your network to
ping the server's hostname (from the command prompt, type ping
followed by the hostname). Be aware that it may take a few minutes for the
DHCP settings to take effect. If the computer receives a reply to the ping,
then the reader settings have been changed correctly. If you cannot ping
the reader hostname, proceed to the Troubleshooting section (page 48).
Redirect Client Computers to the New Server Address
The new server settings must be entered onto each installation of ProteinChip
data manager client software separately.
1.
Start the client.
2.
In the Login dialog box, click the “…” button. This will open the Servers
dialog box (Fig. 29).