Bio-Rad ProteinChip Data Manager Software - Manual (Page 33)

Page 28 Networking the ProteinChip SELDI System
ProteinChip SELDI System: Reader Guide
Fig. 24: Checking the reader software version.
Set the Reader to DHCP
By default, the reader is configured with the IP address 192.168.1.200 when it
is initially installed, and is set up to communicate with the supplied workstation
(IP address 192.168.1.10). The workstation is used to update the reader
settings.
NOTE
If you need to configure a separate computer to communicate with the
reader, please see the troubleshooting section.
1. Make sure that no one is using the reader.
2. Open Internet Explorer on the client workstation.
3. Enter the following URL into the address bar:
http://192.168.1.200.
The reader web page shown in Fig. 25 will appear.