Dako Pascal - Manual (Page 6)

Pascal Handbook 6
Section 1
Unpacking and Installation
Inspect Packaging
Pascal and its accessories are delivered in one carton. If the instrument or accessories
have suffered any damage in transport, please inform your carrier immediately
.
Note Save shipping carton and components to simplify return in the event that service
is required.
Verify Contents
The Package contains:
Lid with Pressure Gauge and Hot Sticker
Weight (Petcock)
Pan and Gasket (removable)
Body with electric cord and programmable digital timer
Heat Shield
Pascal Quality Strips (S2801)
Note Pascal is a 110V–120V instrument. A step-down transformer is required for
laboratories using Pascal with a 220V–240V electrical source. This step-down transformer
is not supplied within the same box as Pascal.
Install the Pascal
1. Place the body of Pascal on a level surface suitable for laboratory instrumentation.
2. Position Pascal away from direct sunlight and sources of heat or cold.
3. Place the pan in the body. Make sure the outside of the pan is clean and that all
packaging has been removed.
4. Fit the rubber gasket in the top of the pan.
5. Place the heat shield in the center of the pan.
6. Place the weight (petcock) on the vent nozzle. Ensure that it is firmly in place.
7. Rest the lid on the pan until ready to use.