Dell Latitude XT (Late 2007) - Manual (Page 165)

Adding and Replacing Parts 165
NOTICE: Be careful when removing the card to avoid damaging the card, card
cable, or surrounding components.
4 Loosen the captive screw and, lifting the end with the captive screw first,
gently remove the card caddy from your Tablet-PC. If a card is installed in
the card caddy, ensure that excessive force is not applied to the connecting
cable.
5 If a card is installed in the card caddy, disconnect the cable from the card.
Remove the card from the card caddy by gently lifting the plastic securing
tab and sliding the card out of the caddy.
6 If no card was installed in the card caddy, find the cable in the space
opened by removing the card caddy and gently lift the connector end out
so that it is accessible.
Installing a Bluetooth Card
NOTICE: Before touching anything inside your Tablet-PC, ground yourself by
touching an unpainted metal surface, such as the metal at the back of your
Tablet-PC. While you work, periodically touch an unpainted metal surface to
dissipate static electricity, which could harm internal components.
1 Seat the Bluetooth card into the card caddy, sliding the corner with the
hole under the plastic securing tab. The connector end of the card should
be pointing away from the card caddy end with the captive screw.
2 Connect the Bluetooth card cable to the card.
3 Fold the excess cable as shown in the picture below and hold it next to the
card.
1 captive screw 2 card caddy
3 cable connector 4 plastic alignment tab
5 plastic securing tab 6 Bluetooth card
book.book Page 165 Tuesday, May 13, 2008 5:03 PM