Dell Latitude XT (Late 2007) - Manual (Page 182)

182 Adding and Replacing Parts
10 Lift the display assembly from the base, and place the display assembly to
one side.
Installing the Display Assembly
1 Place the display assembly on the base.
2 Feed the Mini-Card antenna cables from the top through the antenna
channel to the bottom of the system.
Align the shrink tube that is wrapped around the antenna cables to the
edge of the palm rest. Make sure the antenna cables are flat (contained
within the recessed area) and do not overlap. Secure the antenna cables
with the tape that was removed from the cables when removing the display
assembly.
NOTE: If the cables do not lie flat in the recessed area or if they overlap the palm
rest, then the keyboard will not sit flat on the palm rest.
1 M2.5 x 5-mm screws (2)
1
book.book Page 182 Tuesday, May 13, 2008 5:03 PM