Display assembly, Removing the display assembly – Dell Latitude XT (Late 2007) User Manual
Page 179
Adding and Replacing Parts
179
2 Connect the coin-cell battery connector to the connector on the system
board.
3 Install the keyboard (see "Installing the Keyboard" on page 177).
4 Install the hinge cover (see "Installing the Hinge Cover" on page 175).
Display Assembly
CAUTION:
Before performing the following procedures, follow the safety
instructions in your
Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching a connector on the back panel of the
Tablet-PC.
NOTICE:
To avoid damaging the system board, you must remove the main battery
before you begin working inside the Tablet-PC.
Removing the Display Assembly
1 Follow the procedures in "Before You Begin" on page 155.
2 Remove the hinge cover (see "Removing the Hinge Cover" on page 174).
3 Remove the keyboard (see "Removing the Keyboard" on page 176).
4 Remove any installed Mini-Cards (see "Removing a Mini-Card" on
5 Use the pull-tab to disconnect the display cable from the system board.
book.book Page 179 Tuesday, May 13, 2008 5:03 PM