Dell PowerEdge T300 - Manual (Page 111)

Installing System Components
111
4 Replace the processor airflow shroud (see "Installing the Processor Airflow
Shroud" on page 72).
5 Replace the system cover (see "Installing the System Cover" on page 67).
System Memory
The six memory module sockets are located on the system board adjacent to
the power supply and can accommodate 512 MB to 24 GB of registered
PC2-4200/5300, 533/667-MHz, DDR2 memory with ECC. See Figure 6-1 for
the location of the memory module sockets.
You can upgrade the system memory by installing combinations of 512-MB,
1-GB, 2-GB, and 4-GB memory modules. You can purchase memory upgrade
kits from Dell.
NOTE:
Memory modules must be PC2-4200/5300 compliant for your system.
Memory Module Installation Guidelines
The memory module sockets are arranged in three banks (1, 2, and 3) on two
channels (A and B).
The memory module banks are identified as follows:
Bank 1: DIMM1_A and DIMM1_B
Bank 2: DIMM2_A and DIMM2_B
Bank 3: DIMM3_A and DIMM3_B
Memory modules must be installed in memory module banks in identical
pairs for configurations with more than one memory module. For example, if
socket DIMM1_A contains a 512-MB memory module, then the second
memory module to be installed must be a 512-MB memory module in socket
DIMM1_B.
Table 3-1 shows examples of different memory configurations, based on the
following guidelines:
• The minimum memory configuration is 512 MB.
• If only one memory module is installed, it must be installed in the
DIMM1_A socket.
• A memory module bank must contain identical memory modules.
book.book Page 111 Sunday, June 21, 2009 10:04 AM