Dell PowerEdge T300 - Manual (Page 86)

86
Installing System Components
7 Replace the processor airflow shroud (see "Installing the Processor Airflow
Shroud" on page 72).
8 Replace the system cover (see "Installing the System Cover" on page 67).
9 Replace the front bezel (see "Installing the Front Bezel" on page 64).
Installing a Diskette Drive
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Unpack the diskette drive, and prepare it for installation.
2 Remove the front bezel (see "Removing the Front Bezel" on page 63).
3 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
4 Remove the system cover (see "Removing the System Cover" on page 66).
5 Remove the processor airflow shroud (see "Removing the Processor Airflow
Shroud" on page 70).
6 Remove the existing diskette drive, if applicable (see "Removing the
Diskette Drive" on page 84).
NOTE:
If the drive bay is empty, remove the EMI filler (see "Removing an EMI
Filler" on page 68).
7 Attach the four shoulder screws to the diskette drive. See Figure 3-16.
NOTE:
If the diskette drive you are installing does not have shoulder screws,
remove the four shoulder screws from the old drive or the back of the 3.5-inch
insert.
book.book Page 86 Sunday, June 21, 2009 10:04 AM