Dell PowerEdge T300 - Manual (Page 36)

36
About Your System
Plug & Play
Configuration Error
Error encountered in
initializing PCIe device;
faulty system board. Install the NVRAM_CLR
jumper and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists, see
"Troubleshooting Expansion
Cards" on page 159.
Read fault
Requested sector
not found
The operating system
cannot read from the hard
drive or USB device, the
system could not find a
particular sector on the
disk, or the requested
sector is defective. Replace the USB medium or
device. Ensure that the USB
or hard drive cables are
properly connected. See
"Troubleshooting a USB
Device" on page 138, or
"Troubleshooting a Hard
Drive" on page 153 for the
appropriate drive(s) installed
in your system.
Remote
configuration
update attempt
failed
System unable to process
Remote Configuration
request. Retry Remote Configuration.
ROM bad checksum =
address
Expansion card
improperly installed or
faulty. Reseat the expansion card(s)
and expansion card cables. If
the problem persists, see
"Troubleshooting Expansion
Cards" on page 159.
SATA PORT n drive
not found
SATA port x was turned
on in setup, but a drive
was not found. See "Troubleshooting a Hard
Drive" on page 153 for the
appropriate drive(s) installed
in your system.
Sector not found
Seek error
Seek operation
failed
Faulty hard drive, USB
device, or USB medium. See "Troubleshooting a USB
Device" on page 138 or
"Troubleshooting a Hard
Drive" on page 153 for the
appropriate drive(s) installed
in your system.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 36 Sunday, June 21, 2009 10:04 AM