Dell PowerEdge T300 - Manual (Page 20)

20
About Your System
Table 1-5. LCD Status Messages
Code Text Causes Corrective Actions
N/A SYSTEM NAME A 62-character string that
can be defined by the user in
the System Setup program.
The SYSTEM NAME
displays under the following
conditions:
• The system is powered on.
• The power is off and
active errors are displayed.
This message is for
information only.
You can change the
system ID and name in
the System Setup
program (see "Entering
the System Setup
Program" on page 41).
E1000 FAILSAFE,
Call Support
Check the system event log
for critical failure events. See "Getting Help" on
page 175.
E1114 Temp Ambient Ambient system
temperature is out of
acceptable range. See "Troubleshooting
System Cooling
Problems" on page 145.
E1115 Temp Planar Planar system temperature
is out of acceptable range. See "Troubleshooting
System Cooling
Problems" on page 145.
E1118 CPU Temp
Interface
The BMC is unable to
determine the CPU(s)
temperature status.
Consequently, the BMC
increases the CPU fan speed
to maximum
as a precautionary measure. Turn off power to the
system and restart the
system. If the problem
persists, see "Getting
Help" on page 175.
E1210 CMOS Batt CMOS battery is missing, or
the voltage is out of
acceptable range. See "Troubleshooting the
System Battery" on
page 143.
E1211 ROMB Batt RAID battery is either
missing, bad, or unable to
recharge due to thermal
issues. Reseat the RAID battery
connector. If the problem
persists, replace the
battery.
E12 nn ## PwrGd Specified voltage regulator
has failed. See "Getting Help" on
page 175.
book.book Page 20 Sunday, June 21, 2009 10:04 AM