Dell PowerEdge T605 User Manual
Page 122
122
Installing System Components
3 Remove the expansion card shroud. See "Removing the Expansion Card
4 Locate the USB connector on the system board (see Figure 6-1).
5 Insert the USB memory key into the USB connector on the board. See
Figure 3-30.
6 Install the expansion card shroud. See "Installing the Expansion Card
7 Close the system. See "Closing the System" on page 70.
8 Place the system upright and on its feet on a flat, stable surface.
9 Reattach any peripherals, then connect the system to the electrical outlet.
10 Turn on the system and attached peripherals.
11 Enter the System Setup program and verify that the USB key has been
detected by the system. See "Using the System Setup Program" on page 43.
Figure 3-30.
Installing an Internal USB Key or NIC TOE key
1
USB memory key
2
internal USB connector
3
TOE key
4
internal TOE connector
1
2
4
3