Removing a non-redundant power supply – Dell PowerEdge T605 User Manual
Page 78
78
Installing System Components
3 Connect the power cable to the power supply.
a
Route the power cable into the cable retention bracket from the power
supply side of the bracket (see Figure 3-7).
b
Loop the cable from the cable retention bracket up to the power plug
at the back of the power supply, and connect the cable.
c
Plug the other end of the cable into a power distribution unit (PDU)
or power outlet.
NOTE:
After installing a new power supply, allow several seconds for the system to
recognize the power supply and determine whether it is working properly. The
power supply status indicator will turn green to signify that the power supply is
functioning properly. See Figure 1-3.
Removing a Non-redundant Power Supply
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Open the system. See "Opening the System" on page 68.
3 Remove the expansion card shroud. See "Removing the Expansion Card
4 Remove the processor shroud. See "Removing the Processor Shroud" on
5 Depending on your system configuration, disconnect the power cables
from the following components where applicable (see Figure 6-1for
connector locations):
•
PWR1 connector on the system board
•
PWR2 connector on the system board
•
PWR3 connector on the system board
•
BP_PWR connector on the optional SAS/SATA backplane
•
Hard drives