Removing an insert on the front drive bezel, Installing an insert on the front drive bezel, The top of the chassis (see figure 3-2) – Dell PowerEdge T605 User Manual
Page 67: Figure 3-2, Tab slots in the chassis (see figure 3-2)
Installing System Components
67
Figure 3-2.
Removing and Installing the Front Drive Bezel
Removing an Insert on the Front Drive Bezel
If you install a drive in the 3.5-inch or 5.25-inch drive bays, first remove the
corresponding insert on the front drive bezel. From the back of the bezel,
squeeze one of the insert tabs inward to unhook it from the tab notch, and
pull the insert away from the bezel (see Figure 3-3).
Installing an Insert on the Front Drive Bezel
If you remove a drive in the 3.5-inch or 5.25-inch drive bays, replace the
corresponding insert on the front drive bezel. From the back of the bezel, fit
one of the insert tabs into a tab notch on the bezel, and push the insert into the
bezel until the opposite tab snaps into place (see Figure 3-3).
1
lever
2
front drive bezel
3
bezel tabs (2)
4
bezel tab slots (2)
3
1
2
4