Dell PowerEdge T605 User Manual
Page 150
150
Installing System Components
2 Remove the front-drive bezel. See "Removing the Front Drive Bezel" on
3 Open the system. See "Opening the System" on page 68.
4 Remove the expansion card shroud. See "Removing the Expansion Card
5 Remove the processor shroud. See "Removing the Processor Shroud" on
6 Open the drive-carrier release handle on each hard drive and partially
extend the drive(s) out of their drive bays. See "Removing a Hot-plug Hard
Drive" on page 88.
7 Disconnect the following cables from the backplane (see Figure 3-42):
•
SAS cable
•
Power cable
•
Backplane cable
8 Remove the SAS/SATA backplane:
a
Pull the blue backplane release pin. See Figure 3-42.
b
While pulling the release pin, slide the backplane to the left.
c
Pull the backplane board until the securing slots are free from the
securing tabs, and lift the board from the chassis.