Dell PowerEdge T605 - Manual (Page 70)

70
Installing System Components
Closing the System
1 Ensure that all internal cables are connected and folded out of the way.
2 Ensure that no tools or extra parts are left inside the system.
3 Reinstall the system cover:
a Lift up the cover latch.
b Place the cover on top of the system and offset the cover slightly
back so that it clears the hook slots and lays flat on the system
chassis. See Figure 3-4.
c Push the latch down to lever the cover into the closed position.
d Turn the latch release lock clockwise to the locked position. See
Figure 3-4.
4 Place the system upright and on its feet on a flat, stable surface.
5 Rotate the system feet outward (see Figure 3-4).
6 Reattach any peripherals, then connect the system to the electrical outlet.
7 Turn on the system and attached peripherals.
After you open and close the cover, the chassis intrusion detector, if
enabled, causes the following message to appear on the screen at the next
system start-up:
Alert! Cover was previously opened.
8 To reset the chassis intrusion detector, press <F2> to enter the System
Setup program. See "Entering the System Setup Program" on page 43.
NOTE:
If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion
detector.