Dell PowerEdge T605 User Manual

Page 155

Advertising
background image

Installing System Components

155

2 Open the system. See "Opening the System" on page 68.
3 Remove the expansion card shroud. See "Removing the Expansion Card

Shroud" on page 72.

4 Remove the processor shroud. See "Removing the Processor Shroud" on

page 72.

5 Depending on your configuration, disconnect the following cables from

the system board. See Figure 6-1 for connector locations.
•

Three power-supply cables from the PWR1, PWR2, and PWR3
connectors

•

I/O panel cable from the

CTRL_PNL

connector

•

SATA cable(s) from the SATA connector(s)

•

Diskette data cable from the FLOPPY connector

•

PATA data cable from IDE connector

•

Expansion card fan cable from the FAN1 connector

•

System fan cable from the FAN2 connector

•

SAS LED cable from the PERC_LED connector

•

SAS/SATA backplane cable from BP_12C connector

•

Intrusion switch cable from the INTRUSION connector

6 If applicable, remove all expansion cards and any attached cables. See

"Removing an Expansion Card" on page 108.

7 If applicable, remove the RAC card. See "Removing the RAC Card" on

page 118.

8 If applicable, remove the SAS controller card. See "Removing a SAS

Controller Card" on page 115.

9 Remove the internal USB memory key, if present. See Figure 6-1 for the

USB socket location.

10 Remove the TOE hardware key, if present. See Figure 6-1 for the

TOE_KEY socket location.

11 Remove all memory modules. See "Removing Memory Modules" on

page 133.

NOTE:

Record the memory-module socket locations to ensure proper

reinstallation of the memory modules.

Advertising