Installing a hot-plug hard drive, Figure 3-13 – Dell PowerEdge T605 User Manual
Page 89
Advertising
Installing System Components
89
NOTICE:
To maintain proper system cooling, all empty hard-drive bays must have
drive blanks installed.
Figure 3-13.
Removing and Installing a Hot-plug Hard Drive
Installing a Hot-plug Hard Drive
NOTE:
It is recommended that you use only drives that have been tested and
approved for use with the SAS/SATA backplane.
NOTICE:
Not all operating systems support hot-plug drive installation. See the
documentation supplied with your operating system.
1 Remove the front drive bezel, if attached. See "Removing the Front
2 If a drive blank is present in the bay, remove it. See "Removing a Hot-plug
1
hard-drive carrier handle
2
lever-release drive bay
1
2
Advertising