Dell PowerEdge T605 User Manual

Page 38

Advertising
background image

38

About Your System

ROM bad checksum

= address

Expansion card improperly
installed or faulty.

Reseat the expansion card(s).
Ensure that all appropriate
cables are securely connected
to the expansion card(s). If
the problem persists, see
"Troubleshooting Expansion
Cards" on page 186.

SATA PORT x drive

not found

SATA port x was turned on in
setup, but a drive was not
found.

See "Troubleshooting a Hard
Drive" on page 181 for the
appropriate drive(s) installed
in your system.

Sector not found

Seek error

Seek operation

failed

Faulty hard drive, USB
device, or USB medium.

See "Troubleshooting a USB
Device" on page 165 or
"Troubleshooting a Hard
Drive" on page 181 for the
appropriate drive(s) installed
in your system.

Shutdown failure

Shutdown test failure.

See "Troubleshooting System
Memory" on page 173.

Spare bank

enabled

DIMM sparing has been
enabled.

Information only.

The amount of

system memory has

changed

Memory has been added or
removed or a memory
module may be faulty.

If memory has been added or
removed, this message is
informative and can be
ignored. If memory has not
been added or removed,
check the SEL to determine
if single-bit or multi-bit
errors were detected and
replace the faulty memory
module (see
"Troubleshooting System
Memory" on page 173).

Table 1-6.

System Messages (continued)

Message

Causes

Corrective Actions

Advertising