Installing the power supply distribution board, Figure 3-41 – Dell PowerEdge T605 User Manual
Page 148
Advertising
148
Installing System Components
b
Install a non-redundant power supply. See "Installing a Non-redundant
Power Supply" on page 81.
Figure 3-41.
Removing and Installing the Power Supply Cage Cover
Installing the Power Supply Distribution Board
1 If present, remove the power supply cage cover.
Pull the blue release pins until the cover is free from the alignment holes,
and lift the cover out of the chassis. See Figure 3-41.
2 Position the power supply distribution board so that the securing tabs on
the chassis are fully inserted into the securing slots on the board. See
Figure 3-40.
1
power supply cage cover
2
release pins (2)
3
release pin alignment holes (2)
4
power supply cage
1
3
2
4
Advertising