Dell 2130cn Color Laser Printer - Manual (Page 165)

802.1x
Purpose:
To specify the settings for IEEE 802.1x authentication for encrypted communication to the printer.
Values:
Reset Print Server
Purpose:
To initialize NVRAM (non-volatile RAM) for the network feature and reboot the printer. You can also initialize the printer's NVRAM from Reset Defaults in the
Printer Settings menu.
Values:
Copy Printer Settings
The Copy Printer Settings menu includes the Copy Printer Settings and Copy Printer Settings Report pages.
Copy Printer Settings
Purpose:
To copy the printer settings to one or more of the same model of the printer.
To copy the settings to another printer, specify the IP address and password of the printer to which the settings are copied in the IP Address text box and
Password text box. Then, click the Copy the settings to the Host in the above list. button. Copying the settings is complete. The connection time-out period is
60 seconds. After that, you can check whether the settings were copied to this page. And you need to click the Copy the settings to the Host in the above list
and reboot the machine button of the Dell Printer Configuration Web Tool in the destination printer to verify if the settings were actually copied or not.
If the settings can be copied but printer configuration is different, the settings of only the same items are copied. Printer settings are simultaneously copied to
printers of up to 10 IP addresses.
Copy Printer Settings Report
IKE Use a pre shared key for IKE authentication.
Pre-Shared Key Specifies a shared key.
Re-enter Pre-Shared Key Enter the shared key again to confirm it.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28800 minutes.
IPsec SA Lifetime Sets the lifetime for IPsec SA from 5 to 2880 minutes.
DH Group Selects the DH group.
PFS Selects the check box to enable the PFS setting.
Remote peers IPv4 address Specifies the IP address to connect to.
Remote peers IPv6 address Specifies the IP address to connect to.
Non IPsec communication policy Selects whether or not to communicate with a device which does not support IPsec.
NOTE: If IPsec is enabled with incorrect settings, you must disable it using the IPsec menu on the operator panel.
NOTE: This item is only displayed when the optional network protocol adapter is installed, and also when the optional wireless printer adapter is not
installed.
Enable IEEE 802.1x Select the check box to enable IEEE 802.1x authentication.
Authentication Method
EAP-MD5
Select the authentication method to use for IEEE 802.1x authentication. EAP-MS-CHAPv2
PEAP/MS-CHAPv2
Login Name: (Device Name) Specifies the login name (device name) for IEEE 802.1x authentication using up to 128 alphanumeric characters.
Password Specifies the login password for IEEE 802.1x authentication using up to 128 alphanumeric characters.
Re-enter Password Enter the login password again to confirm it.
Initialize NIC NVRAM Memory and restart
printer. Click the Start button to initialize NVRAM. Network settings will revert to the factory default settings and reboot
the network capability.
Restart Printer Click the Start button to reboot the printer.