Dell 2130cn Color Laser Printer - Manual (Page 27)

Environment Sensor Info
Purpose:
To output the printer's internal environment sensor information to Result by pressing the Get Environment Sensor Info button.
Developer Stir Mode
Purpose:
To rotate the developer motor and stir the toner in the toner cartridge.
Values:
Refresh Mode
Purpose:
To use up a toner cartridge or PHD unit when you need to replace it before the end of its life, or to stir the toner in a new toner cartridge.
Values:
Back to Contents Page
Paper Size Specifies the size of paper to be used by the Paper Wrinkle Check Mode.
Folio (8.5 x 13")
Legal (8.5 x 14")
Executive (7.25 x 10.5")
Monarch (3.875 x 7.5")
Monarch LEF (7.5 x 3.875")
DL (110 x 220 mm)
DL LEF (220 x 110 mm)
C5 (162 x 229 mm)
Envelope #10 (4.125 x 9.5")
Paper Type
Plain*
Specifies the type of paper to be used by the Paper Wrinkle Check Mode.
Plain Thick
Covers
Covers Thick
Label
Recycled
Envelope
Rear side
Off* Does not use the Print side 2 of the paper.
On Uses the Print side 2 of the paper.
Color Mode
Color* Prints in color mode.
Black Prints in monochrome mode.
Start Click this button to print in the specified paper size, type, and color mode.
Developer Stir Mode Click Start to stir the toner.
CAUTION: Using the Refresh Mode consumes extra toner.
Toner Refresh Mode
Yellow Click Yellow to clean the yellow cartridge.
Magenta Click Magenta to clean the magenta cartridge.
Cyan Click Cyan to clean the cyan cartridge.
Black Click Black to clean the black cartridge.
PHD Refresh Mode PHD Click PHD to clean the PHD unit.