Dell 2130cn Color Laser Printer - Manual (Page 21)

Printer Maintenance
The Printer Maintenance tab includes the System Settings, Paper Density, Registration Adjustment, Adjust Altitude, Reset Defaults, Non-Dell Toner,
Initialize PrintMeter, Tray Settings, TCP/IP Settings, and Network Settings pages.
System Settings
Purpose:
To Use these settings to configure the printer's power management, warning tones, time-out time, operator panel language setting, job log auto print,
position of the Print ID, setting of the dump print, setting of the additional memory, setting of the substitute sheet, mm/inch setting, and duplex print settings.
Values:
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Power Saver Timer
Mode 1*
1
1-30 Min. Specifies the time before the printer enters the power saver timer mode 1(sleep mode) after it
finishes a job.
3 Min.*
Power Saver Timer
Mode 2*
1
5-60 Min.
Specifies the time before the printer enters the power saver timer mode 2 (deep sleep mode) after
it goes into the power saver timer mode 1.
10 Min*
Audio Tones
Control Panel Tone
Off* Does not emit a tone when the operator panel input is correct.
On Emits a tone when the operator panel input is correct.
Invalid Key Tone
Off* Does not emit a tone when the operator panel input is incorrect.
On Emits a tone when the operator panel input is incorrect.
Machine Ready Tone
Off* Does not emit a tone when the printer becomes ready.
On Emits a tone when the printer becomes ready.
Job Complete Tone
Off* Does not emit a tone when a job is complete.
On Emits a tone when a job is complete.
Fault Tone
Off* Does not emit a tone when a job ends abnormally.
On Emits a tone when a job ends abnormally.
Alert Tone
Off* Does not emit a tone when a problem occurs.
On Emits a tone when a problem occurs.
Out of Paper Alert
Tone
Off* Does not emit a tone when the printer runs out of paper.
On Emits a tone when the printer runs out of paper.
Low Toner Alert
Tone Off* Does not emit a tone when toner or some other consumable is low.
On Emits a tone when toner or some other consumable is low.
Base Tone
Off*
Does not emit a tone when the operator panel display is returned to the default settings by
scrolling the loop menu.
On
Emits a tone when the operator panel display is returned to the default settings by scrolling the
loop menu.
Fault Time-Out
0 Disables the fault time-out.
3-300 sec
Specifies the amount of time the printer cancels for a job stops abnormally.
60 sec*
Time-Out
0 Disables the job time-out.
5-300 sec
Specifies the amount of time before the printer cancels for jobs that stop abnormally.
30 sec*
Panel Language
English*
Specifies the language to be used on the operator panel.
French
Italian
German
Spanish
Dutch
Danish
Norwegian
Swedish
Auto Log Print
Off* Does not automatically output a log of completed jobs from the printer.
On Outputs a log of completed jobs from the printer automatically.
Print ID
Off* Does not print the user ID.
Top Left
Prints the user ID on the specified location.
Top Right
Bottom Left