Dell 2130cn Color Laser Printer - Manual (Page 31)

To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP addresses. Any changes made become
effective after the printer is turned off and then on.
Values:
IEEE 802.1x
Purpose:
To disable the IEEE 802.1x authentication. Any changes made become effective after the printer is turned off and then on.
Reset LAN
Purpose:
To initialize wired network data stored in NV (non-volatile) memory. After executing this function and rebooting the printer, all wired network settings are reset
to their default values.
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
Port Status
Purpose:
To enable or disable the USB interface. Any changes made become effective after the printer is turned off and then on.
Values:
System Settings
Use the System Settings menu to configure a variety of printer features.
PowerSaver Time
Purpose:
To specify the time for transition to power saver mode.
Values:
Enter 3 to put the printer in power saver mode three minutes after it finishes a job. This uses much less energy, but requires more warm-up time for the
No. n/Address (n is 1-5.)* 1 Sets the IP address for Filter n.
No. n/Mask (n is 1-5.)* 1 Sets the address mask for Filter n.
No. n/Mode (n is 1-5.)* 1
Off* Disable the IP Filter feature for Filter n.
Accept Accepts an access from the specified IP address.
Reject Rejects an access from the specified IP address.
* 1 This item is only available for LPD or Port9100.
NOTE: This item is only displayed when the IEEE 802.1x authentication is enabled and the optional network protocol adapter is installed, and also when
the optional wireless printer adapter is not installed.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Enable* The USB interface is enabled.
Disable The USB interface is disabled.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
Mode1 3min.*
Specifies the amount of time before the printer enters the power saver mode 1 after it finishes a job.
1-30min.
Mode2
10min.*
Specifies the amount of time before the printer enters the power saver mode 2 after it goes into the power saver mode 1.
5-60min.