Dell 2130cn Color Laser Printer - Manual (Page 66)

094-911
Contact Support
094-911
IfMessageReturns
The DTB unit reaches the end of its life.
Turn the printer off and then on.
If this does not solve the problem, contact Dell.
See " Contacting Dell ".
CRUM ID
093-NNN
Reseat XXX Cartridge
An unsupported unit is installed.
XXX indicates a unit that you replace.
Remove the unsupported unit and install a supported one.
See " Maintaining Your Printer ".
PHD
091-912
Reseat PHD
The eight yellow ribbons are not correctly
removed from the PHD unit.
Ensure that the eight yellow ribbons are correctly removed from the
PHD unit.
If this does not solve the problem, replace the PHD unit.
See " Replacing the Print Head Device (PHD) Unit ".
Shake Cartridge
093-NNN
Remove and Shake
XXX Cartridge
The density of the print cartridge is not
enough.
XXX is one of the following:
Black
Cyan
Yellow
Magenta
Shake the specified toner cartridge five or six times to distribute the
toner evenly and reinsert it.
CTD Sensor Dirty
092-310
Clean CTD Sensor
The CTD sensor is dirty.
Clean the CTD sensor.
See " Cleaning the CTD Sensor Inside the Printer ".
Close XXX Cover
077-NNN
XXX Cover
Is Open
Printer cover is open.
XXX indicates printer cover.
Close the specified cover.
Check Paper Size
024-NNN
Load XXX
xxx
Load XXX
yyy
Incorrect paper size is loaded in the
specified tray.
XXX indicates the number of the tray or
single sheet feeder.
xxx indicates a paper size.
yyy indicates paper quality.
Load the specified paper in the specified trays.
See " Loading Print Media in the Standard 250-Sheet Tray and
Optional 250-Sheet Feeder " and " Loading the Single Sheet Feeder ".
Out of Memory
016-700
Job too Large
Press
The printer memory is full and cannot
continue processing the current print job.
Press (Set) button to clear the message, cancel the current print
job, and conduct the next print job, if any.
Press Cancel button to cancel the print job.
Press Menu button to open Stored Print and delete the holding job.
To avoid this error in the future, do the following:
Delete unnecessary fonts, macros, and other data in printer memory.
Install additional printer memory.
See " Printing Held and Proof Print Jobs ".
Disk Full
016-980
Job too Large
Press
RAM disk memory is full and cannot continue
processing the current print job.
Press (Set) button to clear the message, cancel the current print
job, and conduct the next print job, if any.
Press Cancel button to cancel the print job.
Press Menu button to open Stored Print and delete the current job.
To avoid this error in the future, do the following:
Reduce the number of print pages such as splitting the print data.
Increase free memory space by deleting unnecessary data in the RAM
disk.
See " Printing Held and Proof Print Jobs ".