Dell 2130cn Color Laser Printer - Manual (Page 22)

Paper Density
Purpose:
To specify the paper density settings.
Values:
Registration Adjustment
Purpose:
To set Color Registration Adjustment (individual yellow, magenta, cyan correction) settings. When Auto Registration Adjustment is set to On, the printer
prints the color registration chart and adjusts the color registration by using the chart. This function is required after the printer is set up or moved.
Values:
Bottom Right
Print Text
Off Does not print the received PDL data as text data.
On* Prints the received PDL data as text data.
Banner Sheet Insert
Position
Off* Does not insert the banner sheet.
Front
Inserts the banner sheet to the specified position. Back
Front & Back
Banner Sheet Specify
Tray
Tray 1*
Specifies the input tray to insert the banner sheet.
Tray 2* 2
RAM Disk* 3
Disable
Does not allocate RAM for the disk file system. Secure Print, and Proof Print jobs will abort and be
recorded to the job log.
50–500MB* 4
Allocates RAM for the disk file system automatically.
50–1000MB* 5
Odd Page 2 Sided
1 Sided* Prints the odd last page upside down to the paper.
2 Sided Prints the odd last page in normal direction to the paper.
Substitute Tray
Off No tray size substitute accepted.
Larger Size
Substitutes paper of next largest size. When there is no larger paper size, the printer substitutes
paper of nearest size.
Nearest Size* Substitutes paper of nearest size.
mm/inch
millimeter (mm)*
Selects millimeter or inch as the default measurement unit.
inch (") * 6
Apply New Settings After you complete the settings, press the Apply New Settings button to apply the changes.
Restart printer to apply new settings Press the Restart printer to apply new settings button to apply the changes.
* 1 Enter 3 to put the printer in the power saver timer mode three minutes after it finishes a job. This uses much less energy, but requires more warm-up
time for the printer. Enter 3 if your printer shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum warm-up time. Select a
value between 1 and 30 minutes for the power saver timer mode if you want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver timer mode when it receives data from the computer. You can also return the
printer to the standby mode by pressing any button on the operator panel.
* 2 This item is only available when the optional 250-sheet feeder is installed.
* 3 This item is only available when the 512 MB, or higher, optional memory is installed.
* 4 Only displayed when the optional 512 MB memory is installed.
* 5 Only displayed when the optional 1024 MB memory is installed.
* 6 The factory default setting of mm/inch is set to inch(") in the United States.
Plain
Normal*
Specifies plain paper density settings.
Light
Label
Normal*
Specifies label paper density settings.
Light
Apply New Settings After you complete the settings, press the Apply New Settings button to apply the changes.
Restart printer to apply new settings Press the Restart printer to apply new settings button to apply the changes.