Dell PowerVault 725N (Rackmount NAS Appliance) - Manual (Page 125)

f. When prompted to reboot the client system, click Yes.
The Resource CD is no longer required; remove it from the client system.
11. Insert the Reinstallation CD into the client system's CD drive.
12. Turn on the NAS system.
The system must be turned on so that you can set the IP address using the Dell OpenManage™ Kick -Start utility.
13. Enable the Kick-Start utility and create your DHCP settings:
a. Click the Start button and point to Programs→ Dell Reinstallation Console→ Dell OpenManage Kick-Start.
b. When asked if you want to run the program, click Yes.
c. At the bottom of the Dell OpenManage Kick-Start window, click Setup.
d. Click Add.
e. In the Add Scope window, enter the following information and click OK:
l 10.40.10.10 for Starting IP Address
l 10.40.10.20 for Ending IP Address
l 255.255.255.0 for Subnet
l 10.40.10.1 for Gateway IP Address
f. Click OK to close the Add Scope window.
g. Click Interfaces for DHCP Server.
h. Click OK to close the Setup window.
i. Click Enabled at the bottom of the Dell OpenManage Kick-Start window to start the integrated DHCP server.
14. Start the Intel® PXE server and verify that the services are running:
a. Click the Start button and point to Programs→ Dell Reinstallation Console→ Intel PXE Server.
b. In the PXE Configuration Utility window, right-click the server name, PV725REC, and then select Start/Stop Services.
c. Verify that the proxy DHCP/Boot PXE and M/TFTP services are installed and running correctly by selecting Stop and then selecting Start.
If the services are running, ensure that the message Started is displayed after you click Start and Stopped is displayed after you click Stop on the
indicator.
d. Click OK.
15. Reboot the NAS system by pressing the power button for less than 2 seconds.
16. On the keyboard connected to the NAS system, press <F2> immediately after you see the following message:
Press <F2> to enter the Function Select menu.
17. From the menu, select option 4, Reinstallation, and then type y to confirm the selection.
18. When the screen warns that you are going to reinstall and that it will erase data, type y .
19. Press y again to confirm the selection.
Depending on your configuration, this process could take several hours to complete. When the reinstallation is complete, the NAS system shuts down.
20. After the NAS system shuts down, reboot the system.
The system is set to the preinstalled settings.
21. Reconfigure the system.
See " Configuring Your NAS System for the First Time " in the "Initial Configuration" section of this guide.
NOTE: During the reinstallation, do not attempt to connect to your NAS system.