Disk quotas, Removing a share, Removing a protocol from the share – Dell PowerVault 725N (Rackmount NAS Appliance) User Manual
Page 81
The Share Properties page displays. Use this page to change the description of the share. You can also select the type of client from which the share is
accessible.
6.
Click OK.
Removing a Share
When you remove a share, access to the share is removed; however, the actual files remain on the NAS system.
To remove a share, perform the following steps:
1.
Log in to the NAS Manager.
2.
Click Shares.
3.
On the Shares page, click Shares.
4.
In the Shared Folders table, click the share that you want to delete.
5.
Click Delete.
A confirmation dialog appears.
6.
Click OK to confirm the deletion, or click Cancel to keep the share.
Removing a Protocol From the Share
Because a share may have more than one protocol assigned, it is possible to remove a protocol from a share without removing the remaining protocols.
To remove one or more specific protocols from a share, perform the following steps:
1.
Log in to the NAS Manager.
2.
Click Shares.
3.
On the Shares page, click Shares.
4.
In the Shared Folders table, click the share for which you want to remove a protocol.
5.
Click Properties.
6.
Uncheck the protocol(s) to remove it from the share.
7.
Click OK to confirm the protocol removal, or click Cancel to keep the protocol(s) for the share.
Disk Quotas
Disk quotas track and control the use of disk space for volumes. You can configure the volumes on your NAS system to:
l
Prevent further use of disk space and log an event when a user exceeds a specified disk space limit.
l
Log an event when a user exceeds a specified disk space warning level.
When you enable disk quotas, you can set both the disk quota limit and the disk quota warning level.
l
The disk quota limit specifies the amount of disk space a user is allocated within a specific volume.
l
The warning level specifies the point at which the event log displays that a user is nearing the quota limit within a specific volume.
For example, you can set a user's disk quota limit to 50 MB and the disk quota warning level to 45 MB. With these settings, the user can store no more than
50 MB on the volume. If the user stores more than 45 MB on the volume, you can set the disk quota system to log a system event to the event log.