Rescanning for hardware-raid nas system disks – Dell PowerVault 725N (Rackmount NAS Appliance) User Manual
Page 92
1.
Log in to the NAS Manager.
See "
" in this section of the guide.
2.
Click Disks.
3.
On the Disks page, click Disks.
4.
In the Physical Disks column on the Disks page, select the disk to rescan.
5.
In the Tasks list, click Rescan.
6.
On the Rescan page, click OK to start the rescan.
Listing Available Hardware-RAID NAS System Disks and Viewing Properties
1.
Log in to the NAS Manager.
See "
" in this section of the guide.
2.
Click Disks.
3.
On the Disks page, click Disks.
The Disks page displays a list of the hardware RAID card and shows its status and firmware revision.
4.
In the Tasks list, click Select.
The CERC ATA100/4ch Controller 0 Card page displays a list of the available disks and their status.
5.
Click a disk and click Properties.
The Properties page displays the status, capacity, device type, and vendor for the selected disk.
Rescanning for Hardware-RAID NAS System Disks
1.
Log in to the NAS Manager.
See "
" in this section of the guide.
2.
Click Disks.
3.
On the Disks page, click Disks.
The Disks page displays a list of the hardware RAID card and its status and firmware revision.
4.
In the Tasks list, click Select.
The CERC ATA100/4ch Controller 0 Card page displays a list of the available disks and shows their status.
5.
In the Physical Disks column on the Disks page, select the disk to rescan.
Determining if a NAS System Uses
Software RAID or Hardware RAID
" in this section of the guide.
Determining if a NAS System Uses
Software RAID or Hardware RAID
" in this section of the guide.
Determining if a NAS System Uses