Dell PowerVault 725N (Rackmount NAS Appliance) - Manual (Page 74)

f. At the bottom of the Dell OpenManage Kick-Start window, click Setup.
g. Click Add.
h. In the Add Scope window, type the following information and click OK:
l Starting IP Address: 10.40.10.10
l Ending IP Address: 10.40.10.20
l Subnet: 255.255.255.0
l Gateway IP Address: 10.40.10.1
i. Click OK to close the Add Scope window.
j. Click Interfaces for DHCP Server so that it is checked.
k. Click OK to close the DHCP Server Setup window.
5. Click Enabled at the bottom of the Dell OpenManage Kick-Start window to start the integrated DHCP server.
6. Push the power button to turn on the NAS system.
After the system boots, it is displayed in the Discovered Systems list of the Dell OpenManage Kick-Start window.
7. Click the NAS system in the Discovered Systems list.
8. Click Launch Configuration Tool to launch the NAS Manager.
The Configuring icon is displayed for 5 minutes after you click Launch Configuration Tool. If the agent is still running after 5 minutes, the icon displays
"Ready."
9. Use the NAS Manager to configure the NAS system's IP address.
See " Configuring the Network Address for the NAS System " in the "NAS Manager" section of this guide.
Other Documents You May Need
l The Rack Installation Guide included with your rack solution describes how to install your system into a rack.
l The Setting Up Your System document provides an overview of initially setting up your system.
l The User's Guide provides information about system features and technical specifications.
l The Installation and Troubleshooting Guide describes how to troubleshoot the system and install or replace system components.
l Documentation for any components you purchased separately provides information to configure and install these options.
l Updates are sometimes included with the system to describe changes to the system, software, and/or documentation.
l Release notes or readme files may be included to provide last-minute updates to the system or documentation or advanced technical reference material
intended for experienced users or technicians.
Back to Contents Page
NOTE: Ensure that the client system is on the same subnet as the NAS system. Because the NAS system is assigned an address on the
10.40.10.x subnet, the client system IP address must also be statically assigned to the 10.40.10.x subnet.
NOTE: It may take several minutes for the NAS system to boot, depending on your configuration.
The System Information Guide provides important safety and regulatory information. Warranty information may be included within this document or as a
separate document.
NOTE: Always read the updates first because they often supersede information in other documents.