SINGER 8500Q MODERN QUILTER Instruction Manual - Manual (Page 82)

80
QUARTER INCH FOOT WITH GUIDE
This Quarter Inch Foot with Guide gives a perfect 1/4” seam
guideline, which is used for piecing quilt blocks. Markings on
the foot alert when to pivot the fabric. The Quarter Inch Foot
with Guide is also perfect for narrow seams, such as those in
doll clothes or baby garments.
LARGE EXTENSION TABLE
ASSEMBLY
1. Adjust legs to same height.
,QVWDOOOHJVE\SODFLQJWDEOHXSVLGHGRZQRQD¿UPVXUIDFH
protected with a soft towel. Push legs all the way onto four
leg extensions. Turn table upright.
3. Remove accessory box and slide table into place (if legs
are not attached or not at the right height, the table may not
slide into place correctly).
4. Readjust legs height if needed, so that the table is flush
around sewing machine (unevenness of table could cause
uneven feeding of fabric when sewing).
REMOVING LEGS TO TRANSPORT OR STORE
5HPRYHOHJVE\SODFLQJWDEOHXSVLGHGRZQRQD¿UPSURWHFWHG
surface and gently rock legs back and forth and pull gently up.
DO NOT TWIST LEGS OR PICK TABLE UP BY LEGS.
INSTRUCTIONS FOR SEWING PERFECT CIRCLES
The holes provided on the table are in increments of 1/2". The
6 increments provided on table will offer a variety of circle
sizes.
1. Attach large extension table.
2. Remove clutch from pin.
3. Install pin over fabric into desired hole on table.
4. Push clutch onto pin below table, as shown in illustration.
Be careful to not force pin and clutch too tightly. The fabric
needs to rotate easily on pin for even feeding.
1. Place two pieces of cotton fabric, right sides together,
under the Quarter Inch Foot with Guide.
2. Select Straight Stitch. Set the stitch width to 3.6. Turn the
hand wheel toward you to make sure that the needle is
lined up in the correct position.
3. Sew, keeping the fabric’s edge even with the foot’s right
edge.
4. When the fabric reaches the foot’s ¼-turn mark, leave
the needle in the fabric, pivot the fabric and start the next
perfect ¼” seam.
For Full Video Instructions, Visit YouTube.com/
SingerSewingCompany
CAUTION: Do not place anything hot on table surface.
Do not stand on, lean on, or apply any unnecessary
pressure on the table.
Pin inserts into table at hole.
La broche s’insert dans le trou de la table.
Inserte el perno en el agujero de la mesa.
Clutch attaches to pin under table.
Le boulon s’attache à la broche sous la table.
El acoplamiento se adapta contra el perno debajo
de la mesa.