CANOGA PERKINS 9175 Command Reference - Manual (Page 142)

CanogaOS Command Reference
8-6
Switch(config-if)# exit
Switch(config)# erps 11 ring 1 primary interface eth-0-9
And you can check the result by using “show erps 11” command.
Switch# show erps 11
ERPS domain ID: 11
ERPS domain name: test11
ERPS domain primary control VLAN ID: 16
ERPS domain sub control VLAN ID: 15
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 5 second(s)
ERPS ring ID: 1
ERPS ring level: sub
ERPS ring 1 node mode: transit
ERPS ring 1 node state: idle
ERPS ring 1 primary interface name: eth-0-9
ERPS ring 1 secondary interface name: not configured
Related Commands
None
8.7 erps ring edge-mode
Use this command to set/unset specific ERPS ring instance edge node mode.
Command Syntax
erps ERPS_ID ring RING_ID edge-mode (edge | assistant-edge)
no erps <1-255> ring RING_ID edge-mode
ERPS_ID : <1-255> ERPS domain ID
RING_ID : <1-255> ERPS ring ID
edge-mode: erps edge mode
edge: edge node
assistant-edge: assistant-edge node
Command Mode
Global configuration
Usage
Once a node is set to edge/assistant-edge node, it will be set to transit node automatically.
Examples
This example shows how to set node as ERPS domain 11 ring 1 edge node.
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.